How to KFB – Knit Front and Back

KFB, or knit front and back, is a commonly used increase stitch in knitting. This can also be referred to as a bar increase.

To do the knit front part, knit the stitch as you would normally but when you pull the loop through do not remove the old stitch from the left hand needle.

To do the knit back part, insert the tip of the right hand needle into the middle of the stitch on the left hand needle from right to left and bring the yarn around the right hand needle from back to front (as a normal knit stitch). Pull the needle back through with the new loop on it and slip the old stitch off the left hand needle.

Voila! One increase made!

Kx

 

How to SKPO – Slip One, Knit One, Pass the Slipped Stitch Over

Confused? It’s a bit of a tongue twister but it very straight forward to do. This creates a decrease with a slight left lean. Insert the right needle into the first stitch on the left needle as if you are going to knit it. Instead of wrapping the yarn around the right needle, simply slip the stitch from the left needle onto the right needle. Knit the next stitch on the left hand needle as normal. Insert the left needle into the second stitch on the right needle, lift it up and over the first stitch and drop it off the end of the right needle. All done!

Kx

How to K2TOG – Knit Two Together

Befuddled by a K2TOG in your pattern? Fear not. K2TOG stands for knit two together. It is a decrease stitch that slants slightly to the right. Sometimes this is in order to decrease the number of stitches in a row ( e.g. to shape an armhole in a jumper) or it is used as part of the stitch pattern. If used as part of the stitch pattern it will usually be balanced with an instruction to make a stitch somewhere in the row so that you maintain the same number of stitches in each row.

Instructions:

This stitch will be performed on the first 2 stitches on the left hand needle. To start with, it might help if you squish these 2 stitches up close to each other. We are going to treat these 2 stitches as 1 stitch so it might help, to begin with, to squish them together. Insert the right hand needle into this squished together “stitch” exactly as if you were knitting 1 stitch, yarn round needle just like a knit stitch and pull through. Slip both stitches off the left needle. You will notice that there are 2 loops around the bottom of the new stitch on the right needle. Easy peasy!

Kx

How to knit a cabled braid

Super good morning to you all!

Just a quick one this morning. Here is a cabled braid that you can use to embellish ready made objects, use as a belt or bookmark etc. You can find my tutorial on how to cable without a cable needle here.

Knitted Cabled Braid

You will need:
Yarn
Correct size needles for your yarn
Cable needle if using

Instructions:

Cast on 10 stitches
Row 1: Purl all stitches
Row 2: K2, C4F, C4F
Row 3: Purl all stitches
Row 4: C4B, C4B, K2

Repeat these 4 rows until the desired length is reached.

Knitted Cabled Braid

I would keep everything relaxed and cast off  loosely. If you don’t everything gets tight and tricky to do.

Don’t forget, you can email me pictures of your finished pieces (or even just started pieces) at katie@buttonsandpickles.com and I’ll pop them up in the gallery on the site.

Enjoy!

Kx